Nouveau Wedding Ring
Posted: Wed Dec 27, 2017 2:36 pm
Help! I purchased the book, templates and some interfacing (not marked). I followed the directions and when I cut the interfacing as instructed, i placed it on the arc and sewed 1/4 inch and turned the arc. Arc is now 3/4" wide from the 3x10 strip. I then marked the 4 corners of the 13 inch block and placed the arc--it's not long enough and doesn't reach the marked corners but the center line is in place. What did I do wrong? The only thing I can think of is that I should not have sewn the interfacing 1/4 inch but the book didn't state so I assumed. Any suggestions? I'm glad I only cut a set of 6 strips! On EB's YouTube video, she used the marked interfacing which I did not use.