Welcome to the new Quilt in a Day community pages. Please use your old username and password to log in. If you forgot your password, you can reset it from the log in page. If you have questions about how the new board works, try the FAQ link above.


Stuck on a block, confused about directions, or have an incredible tip? Try this forum if you're looking for help or guides to improve your quilting techniques.
Post Reply
Posts: 1
Joined: Wed Apr 12, 2017 6:36 am


Post by Christie0707 » Thu Apr 13, 2017 5:22 am

Is 2 1/2 the widest binding I can add to get the mitered corner?

Posts: 13531
Joined: Mon Dec 29, 2008 6:42 pm

Re: Binding

Post by auntjana » Thu Apr 13, 2017 6:44 am

It isn't the width that you need to worry about, it is that you turn the corner at a 45 degree to get the miter. Turn the corner the same way as usual, just paying attention to your seam width.

I was taught the rule of 6 - that is 6 times your seam width, will give you the top, enough for the thickness of the batting, and the back. That is using binding that is folded in half - before you sew it on.

So if you want a wider binding, adjust the seam width, then, cut the width you need, watch the turn on the corner and you will be fine.


Post Reply

Return to “Quilting Technique Discussions”